Detections
Analytics

CISC-RT-000920 - The Cisco Multicast Source Discovery Protocol (MSDP) router must be configured to filter received source-active multicast advertisements for any undesirable multicast groups and sources.

Information

The interoperability of BGP extensions for interdomain multicast routing and MSDP enables seamless connectivity of multicast domains between autonomous systems. MP-BGP advertises the unicast prefixes of the multicast sources used by Protocol Independent Multicast (PIM) routers to perform RPF checks and build multicast distribution trees. MSDP is a mechanism used to connect multiple PIM sparse-mode domains, allowing RPs from different domains to share information about active sources. When RPs in peering multicast domains hear about active sources, they can pass on that information to their local receivers, thereby allowing multicast data to be forwarded between the domains. Configuring an import policy to block multicast advertisements for reserved, Martian, single-source multicast, and any other undesirable multicast groups, as well as any source-group (S, G) states with Bogon source addresses, would assist in avoiding unwanted multicast traffic from traversing the core.

Solution

Configure the MSDP router to filter received source-active multicast advertisements for any undesirable multicast groups and sources as shown in the example below.

R8(config)#ip access-list extended INBOUND_MSDP_SA_FILTER
R8(config-ext-nacl)#deny ip any host 224.0.1.3 log ! Rwhod
R8(config-ext-nacl)#deny ip any host 224.0.1.24 log ! Microsoft-ds
R8(config-ext-nacl)#deny ip any host 224.0.1.22 log ! SVRLOC
R8(config-ext-nacl)#deny ip any host 224.0.1.2 log ! SGI-Dogfight
R8(config-ext-nacl)#deny ip any host 224.0.1.35 log ! SVRLOC-DA
R8(config-ext-nacl)#deny ip any host 224.0.1.60 log ! hp-device-disc
R8(config-ext-nacl)#deny ip any host 224.0.1.39 log ! Auto-RP
R8(config-ext-nacl)#deny ip any host 224.0.1.40 log ! Auto-RP
R8(config-ext-nacl)#deny ip any 232.0.0.0 0.255.255.255 log ! SSM range
R8(config-ext-nacl)#deny ip any 239.0.0.0 0.255.255.255 log ! Admin scoped range
R8(config-ext-nacl)#deny ip 10.0.0.0 0.255.255.255 any log ! RFC 1918 address range
R8(config-ext-nacl)#deny ip 127.0.0.0 0.255.255.255 any log ! RFC 1918 address range
R8(config-ext-nacl)#deny ip 172.16.0.0 0.15.255.255 any log ! RFC 1918 address range
R8(config-ext-nacl)#deny ip 192.168.0.0 0.0.255.255 any log ! RFC 1918 address range
R8(config-ext-nacl)#permit ip any any log
R8(config-ext-nacl)#exit
R8(config)#ip msdp sa-filter in x.1.28.2 list INBOUND_MSDP_SA_FILTER

See Also

https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_Cisco_IOS_Router_Y25M01_STIG.zip

Item Details

Category: ACCESS CONTROL

References: 800-53|AC-4, CAT|III, CCI|CCI-001368, Rule-ID|SV-216635r1050881_rule, STIG-ID|CISC-RT-000920, STIG-Legacy|SV-105807, STIG-Legacy|V-96669, Vuln-ID|V-216635

Plugin: Cisco

Control ID: 6f9133d32592607a9df200a7d993e31420d3f024f0a55b27ff2988b0b498613b