Detections
Analytics
VCST-80-000037 The vCenter STS service must be configured to use a specified IP address and port.
Information
The server must be configured to listen on a specified IP address and port. Without specifying an IP address and port for server to use, the server will listen on all IP addresses available.Accessing the hosted application through an IP address normally used for nonapplication functions opens the possibility of user access to resources, utilities, files, ports, and protocols that are protected on the desired application IP address.
Solution
Navigate to and open:/usr/lib/vmware-sso/vmware-sts/conf/server.xml
The STS service has 2 connectors with the below pairs of ports and addresses.
Navigate to the target <Connector> node and configure the port and address as follows.
port="${bio-custom.http.port}"
address="localhost"
port="${bio-ssl-localhost.https.port}"
address="localhost"
Restart the service with the following command:
# vmon-cli --restart sts
Note: The connector with port="${bio-ssl-clientauth.https.port}" should not have address set.
See Also
https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_VMW_vSphere_8-0_Y24M08_STIG.zip
Item Details
Category: CONFIGURATION MANAGEMENT
References: 800-53|CM-7b., CAT|II, CCI|CCI-000382, Rule-ID|SV-258978r960966_rule, STIG-ID|VCST-80-000037, Vuln-ID|V-258978
Plugin: Unix
Control ID: e4589f1e0537a3f0e324d46e8864d6234ff7857ba20b223ff90a3596ef434c18