FNFG-FW-000120 - The FortiGate firewall must apply egress filters to traffic outbound from the network through any internal interface.

Information

If outbound communications traffic is not filtered, hostile activity intended to harm other networks or packets from networks destined to unauthorized networks may not be detected and prevented.

Access control policies and access control lists implemented on devices, such as firewalls, that control the flow of network traffic ensure the flow of traffic is only allowed from authorized sources to authorized destinations. Networks with different levels of trust (e.g., the internet) must be kept separated.

This requirement addresses the binding of the egress filter to the interface/zone rather than the content of the egress filter.

NOTE: Nessus has not performed this check. Please review the benchmark to ensure target compliance.

Solution

Log in to the FortiGate GUI with Super- or Firewall Policy-Admin privilege.

1. Click the Policy and Objects.
2. Click IPv4 or IPv6 Policy.
3. Click +Create New.
4. Name the policy and select Incoming and Outgoing Interfaces.
5. Create the policies with authorized sources and destinations.
6. Create the policies with Action set to either DENY or ACCEPT.
7. Ensure the Enable this policy is toggled to right.
8. Click OK.

See Also

https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_FN_FortiGate_Firewall_Y22M10_STIG.zip

Item Details

Category: SYSTEM AND COMMUNICATIONS PROTECTION

References: 800-53|SC-7(11), CAT|II, CCI|CCI-002403, Rule-ID|SV-234153r852963_rule, STIG-ID|FNFG-FW-000120, Vuln-ID|V-234153

Plugin: FortiGate

Control ID: 50244d20828a7328cb4856eb9ab6937bceb00549c3c1150aa25e11e98243bc76