Detections
Analytics
CISC-RT-000850 - The Cisco multicast Rendezvous Point (RP) must be configured to rate limit the number of Protocol Independent Multicast (PIM) Register messages.
Information
When a new source starts transmitting in a PIM Sparse Mode network, the DR will encapsulate the multicast packets into register messages and forward them to the RP using unicast. This process can be taxing on the CPU for both the DR and the RP if the source is running at a high data rate and there are many new sources starting at the same time. This scenario can potentially occur immediately after a network failover. The rate limit for the number of register messages should be set to a relatively low value based on the known number of multicast sources within the multicast domain.Solution
Configure the RP to rate limit the number of multicast register messages.R2(config)#ip pim register-rate-limit nn
See Also
https://dl.dod.cyber.mil/wp-content/uploads/stigs/zip/U_Cisco_IOS-XE_Router_Y26M01_STIG.zip
Item Details
Audit Name: DISA Cisco IOS XE Router RTR STIG v3r5
Category: SYSTEM AND COMMUNICATIONS PROTECTION
References: 800-53|SC-5, CAT|II, CCI|CCI-002385, Rule-ID|SV-216723r855829_rule, STIG-ID|CISC-RT-000850, STIG-Legacy|SV-106157, STIG-Legacy|V-97019, Vuln-ID|V-216723
Plugin: Cisco
Control ID: 1dfaaa33afaa09d91bba0c033a9868bd277665cf19060d6b838354b2c001cbe9