CISC-RT-000310 - The Cisco perimeter router must be configured to restrict it from accepting outbound IP packets that contain an illegitimate address in the source address field via egress filter or by enabling Unicast Reverse Path Forwarding (uRPF).


A compromised host in an enclave can be used by a malicious platform to launch cyberattacks on third parties. This is a common practice in 'botnets', which are a collection of compromised computers using malware to attack other computers or networks. DDoS attacks frequently leverage IP source address spoofing to send packets to multiple hosts that in turn will then send return traffic to the hosts with the IP addresses that were forged. This can generate significant amounts of traffic. Therefore, protection measures to counteract IP source address spoofing must be taken. When uRPF is enabled in strict mode, the packet must be received on the interface that the device would use to forward the return packet, thereby mitigating IP source address spoofing.

NOTE: Nessus has provided the target output to assist in reviewing the benchmark to ensure target compliance.


This requirement is not applicable for the DODIN Backbone.

Configure the router to ensure that an egress ACL or uRPF is configured on internal interfaces to restrict the router from accepting any outbound IP packet that contains an illegitimate address in the source field. The example below enables uRPF.

R5(config)#int g0/1
R5(config-if)#ip verify unicast source reachable-via rx

See Also

Item Details


References: 800-53|SC-5(1), CAT|I, CCI|CCI-001094, Rule-ID|SV-216997r531086_rule, STIG-ID|CISC-RT-000310, STIG-Legacy|SV-106049, STIG-Legacy|V-96911, Vuln-ID|V-216997

Plugin: Cisco

Control ID: f793d7e2c947c6c850e0f1da374c8a0cea8d32de5d0a23106c04fb754cb2d0cd